Engineering Aide with Security Clearance

---

Job description

Engineering Aide Salary: $31/hr.
Location: Orlando, FL (fully on-site)
Industry: Government/Defense
Employment Type: Long term contract with potential for permanent employment
Clearance: Active Secret clearance with investigation in past 5 years
Shift: 1st: 6am to 4:30pm Mon - Thur Qualifications: HS Diploma required
3 years of experience in electrical fabrication (cable and harness, SMT board, test equipment, etc.)
3 years of experience with the interpretation of engineering drawings, schematics, and test and repair procedures
3 years of experience with fabricate electrical test equipment designs from a blueprint of the layout, schematic, bill of material, and engineering practices manual as guidelines
Knowledge and experience in repairs of electro-mechanical assemblies
Knowledge of basic avionics and electronics
Knowledge of troubleshooting and fault isolation of components using general purpose and/or automated test equipment
Knowledge of automated and/or general-purpose test equipment (oscilloscopes, multi-meters, network analyzers and waveform generators)
Ability to properly safety wire assemblies and connectors
Ability to solder and repair cables and harnesses
Basic knowledge of Microsoft Office suite of programs
Ability to work overtime as needed
Active Secret clearance with investigation in past 5 years required Responsibilities: Electro-Mechanical Engineering Aid need to fulfill requirements for program designs and fabricate equipment that will be used in the development and manufacture of tactical hardware. Fabricate electronic, electro-mechanical assemblies (and sub-assemblies) to Engineering drawings. Fabrication will include the ability to place and solder components on circuit cards and sub-assemblies. The fabrication of wiring harnesses will require connector pinning, de-pinning and applying mounting hardware. In addition, these lower-level assemblies are to be built-up into single, or multi-bay cabinet assemblies, for the delivery to Engineering or Manufacturing Production areas. Collaborating with Engineers, and other members of the Fabrication team including other Fabricators, Draftsmen, Procurement, and Quality Inspectors. Reading, interpreting, and occasionally correcting engineering drawings/schematics. Daily activity would include not only a fast-paced fabrication environment, but it would also include using several computer-based programs that will update job status, Quality Inspections, and Engineering changes. EOE/ADA

<!– job description page –>